Toshiba e-STUDIO2008A Service Manual page 195

(4) Release the latch, and remove the 1st
drawer paper width detection switch [4] and
1st drawer paper length detection switch [5].
4.5.31 2nd drawer paper width detection switch (SW8) and 2nd drawer
paper length detection switch (SW9)
(1) Remove the rear cover.
 P. 4-6 "4.1.15 Rear cover"
(2) Remove 1 spring [1] and disconnect 2
connectors [2].
Notes:
When installing, connect the yellow harness
connector to the left side.
(3) Release the latch, and remove the switch
holder [3].
(4) Release the latch, and remove the 2nd
drawer paper width detection switch [4] and
2nd drawer paper length detection switch [5].
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-205
Fig. 4-206
Fig. 4-207
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
4 - 75
DISASSEMBLY AND REPLACEMENT
4