Toshiba e-STUDIO2008A Service Manual page 328

5.4.2 Output check
The status of the output signal can be checked.
<Operation procedure>
Procedure 1
[FS]
[03]
(Code)
Procedure 2
[FS] *1 (Code)
[03]
* To perform the fax line 2 modem test or CML test, press [F1] to switch the line mode. (By
pressing [F1], the line mode is switched between line1 and line 2.)
Procedure 3
[FS] (Code)
[03]
Procedure 4
[FS] [03]
(Code)
Procedure 5
(Code)
[FS] [03]
*1
* To perform the fax line 2 modem test or CML test, press [F1] to switch the line mode. (By
pressing [F1], the line mode is switched between line1 and line 2.)
* Return to the standby screen for code input by pressing [Clear].
Refer to the "Self-diagnostic code list" (separate document) for the codes available in the test mode 03.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SELF-DIAGNOSTIC MODE
Operation
[START]
ON
Operation
S [ T A R ] T
One direction
Operation
[START] [START]
ON
[POWER] OFF
[START]
[START] [Digital keys]
Stop Operation
[START]
code
Test mode
C [ L E A ] R
standby
Operation
[CLEAR]
OFF
[START]
[START]
© 2015 TOSHIBA TEC CORPORATION All rights reserved
5 - 10
[POWER] OFF/ON
OFF
(Exit)
[POWER] OFF/ON
(Exit)
[POWER]
Test mode
OFF/ON
standby
(Exit)
[POWER] OFF/ON
(Exit)