Toshiba e-STUDIO2008A Service Manual page 68

[ 4 ] Bypass feed copying
1. Insert a sheet of paper into the bypass tray.
Bypass paper sensor ON
- "Ready for bypass feeding" is displayed.
2. Press the [START] button
"Ready for bypass feeding" changes to "COPYING"
Exposure lamp ON
Scan motor ON  Carriages -1 and -2 move forward
Polygonal motor rotates in high speed
Main motor and exit motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
3. Bypass feeding
Main charger, developer bias and discharge LED ON. Fans are rotated in high speed.
Bypass feed clutch ON
- The bypass feed roller start to rotate.
Aligning operation
Paper reaches the registration roller
After a certain period of time, the bypass feed clutch OFF
4. Hereafter, the operation 3) through 6) of  P. 3-21 "[ 3 ] Drawer feed copying (1st drawer paper
feeding)" is repeated.
[ 5 ] Interruption copying
1. Press the [INTERRUPT] button
LED "INTERRUPT" ON
Copying operation in progress is temporarily stopped. Carriages -1 and -2 return to appropriate
positions.
"Job interrupted job 1 saved" is displayed.
Automatic density and reproduction ratio 100% are set (The set number remains the same)
2. Select the desired copy condition
3. After the interruption copying is finished:
LED "INTERRUPT" OFF by pressing the [INTERRUPT] button
Equipment returns to the status before the interruption
"Ready to resume job 1" is displayed
4. Press the [START] button
The copying operation before the interruption is resumed.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
OUTLINE OF THE MACHINE
© 2015 TOSHIBA TEC CORPORATION All rights reserved
3 - 22