Toshiba e-STUDIO2008A Service Manual page 476

6.15.3 Stapling/folding position adjustment in saddle stitch unit
Perform this adjustment when the saddle control PC board was replaced or the stapling/folding position
must be changed for some reason.
Prepare 2 types of booklet samples using the main unit and use them for adjustment accordingly.
(1) Create 2 types of booklet samples (1 set each) using the main unit.
Media type
Paper size
Number of sheet
(2) Measure the stapling and folding positions of the samples, and then perform adjustment
accordingly.
For stapling and folding, paper on the stacker of the stacker unit is moved to an exclusive
mechanism for stapling or folding. Therefore adjustment must be performed individually for the
folding stopping position of the stacker and the stapling stopping position.
*Check the folding position at the centerfold page of the sample.
* Check the stapling position at the centerfold page of the sample.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
Sample 1
Recommended paper
A4
5 sheets
Center
Paper exit
fold
direction
page
-2mm - +2mm
Fig.6-96
When the staples are bent
Staple
Do not include the
width of the staples
-0.5mm - +0.5mm
Folding line
Fig.6-97
6 - 92
Sample 2
Recommended paper
A3
5 sheets
-2mm - +2mm
Staple
-0.5mm - +0.5mm
Folding line
© 2015 TOSHIBA TEC CORPORATION All rights reserved