Toshiba e-STUDIO2008A Service Manual page 255

(5) Remove the pressure roller [4] by lifting up
the pressure roller release lever [3].
(6) Remove the 2 levers [5].
4.10.12 Fuser roller
(1) Remove the separation finger.
 P. 4-124 "4.10.6 Separation finger"
(2) Remove the paper entrance guide.
 P. 4-124 "4.10.5 Paper entrance guide"
(3) Remove the pressure roller.
 P. 4-134 "4.10.11 Pressure roller"
(4) Remove the heater lamp.
 P. 4-131 "4.10.10 Center heater lamp
(LAMP1)/side heater lamp (LAMP2)"
(5) Remove 2 E-rings, and then take off the 2
pressure roller release levers [1].
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-364
Fig. 4-365
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
4 - 135
DISASSEMBLY AND REPLACEMENT
4