Toshiba e-STUDIO2008A Service Manual page 193

(6) Disconnect 2 connectors. Remove the 1st
drawer empty sensor [4] and the 1st drawer
tray-up sensor [5].
Notes:
When installing connectors, connect the
white connector to the 1st drawer empty
sensor [4], and the yellow connector to the
1st drawer tray-up sensor [5].
4.5.29 2nd drawer empty sensor (S15) and 2nd drawer tray-up sensor
(S14)
(1) Remove the 1st drawer paper feed unit.
 P. 4-58 "4.5.14 1st drawer paper feed
unit"
(2) Remove the 2nd drawer paper feed unit.
 P. 4-61 "4.5.16 2nd drawer paper feed
unit"
(3) Remove the upper tray-up motor unit.
 P. 4-68 "4.5.22 Upper tray-up motor unit"
(4) Release 1 latch.
(5) Feed out the sensor holder [1] to the rear
side and then remove it.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-199
Fig. 4-200
Fig. 4-201
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
4 - 73
DISASSEMBLY AND REPLACEMENT
4