Toshiba e-STUDIO2008A Service Manual page 394

[C] Reproduction ratio of secondary scanning direction (Fine adjustment of main motor
rotation speed (Copier/Printer))
<Procedure>
Performs FS-05.  (05 Adjustment Mode)
(1)
Press [1]  [TEST PRINT]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from
(2)
the lower drawer (Refer to *).
(3) Check the grid pattern on the test chart printed out and measure the distance C from the 10th
line at the leading edge of the paper to the 30th line of the grid pattern.
* Normally, the 1st line of the grid pattern is not printed.
(4) Check if the distance C is within 200±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance C again.
FS-05  Key in code [4526]  [START]
 (Key in a value (acceptable values: 0 to 255))
 [OK] (Stored in memory)
 "100% A" is displayed
 Press [1]  [TEST PRINT]  (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance C becomes (approx. 0.25 mm/
step).
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
© 2015 TOSHIBA TEC CORPORATION All rights reserved
6 - 10