Option 082, Scalar Calibrated Converter Measurements; Option 083, Vector And Scalar Calibrated Frequency Converter Measurements; Option 1Cm, Rack Mount Kit For Instruments Without Handles; Option 200, Standard 2-Port Configuration - Agilent Technologies N5242A Service Manual

PNA Series Microwave Network Analyzers General Product Information
N5242A Analyzer Options Available

Option 082, Scalar Calibrated Converter Measurements

This option can be added to any option combination that includes Option 080 but does not
include Option 083.
This option enables the additional firmware necessary to make scalar calibrated converter
measurements by providing an intuitive and easy-to-use user interface for setting up
mixer and converter measurements.

Option 083, Vector and Scalar Calibrated Frequency Converter Measurements

This option can be added to any option combination that includes Option 080 but does not
include Option 082.
This option enables the additional firmware necessary to make both vector and scalar
calibrated converter measurements by providing an intuitive and easy-to-use user interface
for setting up mixer and converter measurements. This option includes the
Scalar-Calibrated Converter Measurement (SMC) and the Vector-Mixer Calibration (VMC).

Option 1CM, Rack Mount Kit for Instruments without Handles

Option 1CM provides a rack mount kit that contains a pair of flanges, rack mount rails,
and the necessary hardware to mount the analyzer (not equipped with handles) in an
equipment rack with 482.6 mm (19 inches) horizontal spacing.
Additional kits may be ordered from Agilent. Refer to "Rack Mount Kits" on page 6-83 for
the part numbers.

Option 200, Standard 2-Port Configuration

This is a 2-port network analyzer with an upper frequency limit of 26.5 GHz. This is the
standard 26.5 GHz 2-port analyzer and contains:
• one internal source
• a reference mixer switch
• configurable test set

Option 219, 2-Port with Extended Power Range and Bias Tees

In addition to the Option 200 hardware, this 26.5 GHz 2-port analyzer contains:
• two source attenuators
• two receiver attenuators
• two bias tees

Option 224, 2-Port with 2nd Source, Combiner, and Source Switches

In addition to the Options 200 and 219 hardware, this 26.5 GHz 2-port analyzer contains:
• another internal source with front-panel outputs (SRC 2 OUT1 and SRC 2 OUT 2)
• one source combiner
• three source bypass switches
Service Guide N5242-90001 2-5