Alignments/Adjustments; Slide Shaft Profile Adjustment - ENCAD NovaJet Pro 600e Service Manual

14. Inkjet sputter. If the cartridge heater is set too high, inkjet
15. Improper grounding or earthing. An improper A/C outlet power
16. Static electricity. Using certain types of media (i.e. polyester-
17. Data corruption may also effect banding. If you are using a
18. Overlapping images of different types on the same print may

Alignments/Adjustments

The ENCAD NovaJet PRO 600e printers are designed with a mini-
mum of maintenance requirements in mind. Calibrations include: color
calibration, deadband alignment, and X-axis calibration. The mechani-
cal adjustment requirements include the slide shaft profile and car-
tridge head height adjustments. They do not require any electrical
alignments.

Slide Shaft Profile Adjustment

The NovaJet PRO 600e printers Slide Shaft height is factory set to
1.418" (36mm) from the top of the Slide Shaft to the Platen surface. The
normal operating range for the height of the Slide Shaft is between
1.390" (35.3mm) to 1.440" (36.6mm). The Slide Shaft is firmly mounted
on the outer sides and only has adjustments in the middle portion of the
shaft, to remove any bowing of the shaft's profile. The following proce-
sputter may occur causing intermittent white spots throughout
the print.
ground may cause banding due to excessive noise on the line
between the neutral and ground. Ensure the outlet has a clean
zero ground potential with minimal noise between the neutral
and ground.
based media), static electricity buildup within the media roll
may effect the un-roll resistance and cause momentary banding
to occur. However this has not been tested.
parallel cable that is too long or improperly shielded, the data
being sent to the printer may get corrupted and cause artifacts
in the print.
create color bands between the images at the overlaps (i.e. RGB
images with CMYK images).
NovaJet PRO 600e Service Manual
Maintenance 3-17