Remove The Left, Top, And Right Covers - ENCAD NovaJet Pro 600e Service Manual

NovaJet PRO 600e Service Manual

Remove the Left, Top, and Right Covers

Removing the Left Cover allows access to the left side of the Platen
for removal of the Carriage Assembly, Carriage Drive Belt, Tension
Assembly, and the Cutter Activator. Also located on this side is the
ink reservoirs and the Ink Delivery System portion that is con-
nected to the reservoirs. Removal of the Left Cover is a require-
ment to remove the Lower Roller Assembly and the Vacuum Fan(s)
from inside the Platen.
Removing the Right Cover provides access to the Main Printed
Circuit Board (MPCB), Display and Keypad circuits, Servo Motor,
AC Entry Module and the Power Supply Cooling Fan.
The Top Cover needs to be removed before any of the other covers
can be removed. It also gives access to the Carriage Assembly and the
Service Station when in the open (up) position and the Carriage is at the
Carriage Access position.
To remove the Top Cover:
1. Put the Top Cover in the open position by lifting the front of the
Cover to the full upward position.
2. Depress and hold the retracting stop assembly located on the left
side of the Top Cover to disengage it from the Left Cover.
3. Lift up on the left side of the Top Cover until it clears the Left Cover
while still depressing the retracting stop assembly, then slide the
cover to the left to disengage it from the Right Cover.
5-2 Assembly\Disassembly
Always turn the printer OFF, remove the power cord and
the interface cable before beginning any disassembly pro-
cedures. An electrical shock hazard may be present if
these precautions are not followed.