Install The Ink Delivery System; Remove The Carriage Assembly, Carriage Belt, And The Frame Tensioner - ENCAD NovaJet Pro 600e Service Manual

Install the Ink Delivery System

1. Secure the Ink Delivery System Bracket to the Left Sideplate using
two screws.
2. Reattach the rest of the Ink Delivery System linkage train to the
last link (located on the Left Sideplate).
3. Position the Ink Delivery System into the Support Bracket so that it
is easier to orient the Electronics Cover portion of the system over
the Carriage for reinstallation.
4. Position the Electronics Cover over the Carriage with the back of
the Electronics Cover under the Support Bracket. Depress the two
tabs on each side of the Cover and lower the Assembly onto the
Carriage until it snaps into place.
5. Place the Foam Chain Shelf in the Support Bracket (PRO 60e only.)
Align the left side of the Shelf to the center of the leftmost pinch
roller.
6. Perform steps 1 through 3 and 9 and 10 of the Install the Left, Top,
and Right Covers procedure to install the Left and Top Covers.
Remove the Carriage Assembly, Carriage Belt, and
the Frame Tensioner
1. Perform steps 1 through 13 of the Remove the Left, Top, and Right
Covers procedures to remove the Left, Top and Right Covers.
2. Perform steps 2 through 7 of the Remove the Ink Delivery System
procedures to remove the Ink Delivery System.
3. Using a #2 Phillips screwdriver, remove the four screws that
secures the Left Sideplate Assembly to the Platen. Remove the Left
Sideplate Assembly.
4. Lift up on the connector lock to unlock the Trailing Cable connector
(J1) on the Carriage PCB and remove the end of the Trailing Cable.
NovaJet PRO 600e Service Manual
Assembly\Disassembly 5-23