Table of Contents
Advertisement
Main Menu
6. Adjust the timing belt (see page
7.
Install the lower cover and middle covers.
8. Install the crankshaft pulley, then tighten the pulley
bolt (see page
6-12 ('91-'93)
9.
Check the crankshaft pulley and the camshaft pul-
leys at TDC.
NOTE: To check the camshaft, try to insert 5.0 mm
pin punches as shown when the camshaft is at TDC.
TDC MARK
FRONT:
5.0 mm
PIN PUNCHES
REAR:
TDC MARK
TDC MARK
MIDDLE COVER
TDC MARKS
Table of Contents
6-14 ('91-'93)
or ('94-'96))
or ('94-'96))
TDC MARK
(White paint)
TDC MARKS
BACK COVER
MIDDLE COVER
5.0 mm
PIN PUNCHES
10. If a camshaft is not positioned at TDC, remove the
timing belt and adjust the positioning following the
procedure on page
6-18 ('91-'93)
the timing belt.
11. After installation, adjust the tension of each belt.
See
section 23
for alternator belt tension adjust-
ment.
See
section 22
for A/C compressor belt tension
adjustment.
or
('94-'96)
then reinstall
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
