Acura NSX 1991 Manual page 304

Main Menu
Transmission Assembly
Removal
Make sure lifts are placed properly, and
hoist brackets are attached to correct positions (see
section 1).
CAUTION: Use fender covers to avoid damaging
painted surfaces.
1. Check and record the rear wheel alignment (see
section 18).
2. Disconnect the battery negative (-) and positive (+)
cables from the battery.
3. Drain transmission oil. Reinstall the drain plug with
a new washer.
Corrosion resistant bolt/nut
BACK-UP
LIGHT SWITCH
CONNECTOR
WIRE HARNESS HOLDER
STARTER MOTOR
CABLES
NEUTRAL
POSITION
SWITCH
CONNECTOR
STARTER
MOTOR
Table of Contents
TRANSMISSION
HOUSING BOLTS
TRANSMISSION
GROUND
CABLE
MOUNTING
BOLTS
4. Remove the strut bar.
5. Remove the air cleaner assembly.
6. Remove the connectors from the control box, and
remove the control box.
CAUTION: Do not remove the vacuum tubes from
the control box.
7. Remove the wire harness holder, jumper connector
and transmission ground cable.
8. Disconnect the back-up light switch, neutral posi-
tion switch, differential speed sensor, and vehicle
speed sensor (VSS) connectors.
9. Disconnect the starter motor cables, then remove
the starter motor.
10. Remove the transmission mount.
11. Remove the two transmission housing bolts.
CONTROL BOX
TRANSMISSION
MOUNT
DIFFERENTIAL
SPEED SENSOR
VEHICLE SPEED
SENSOR (VSS)
CONNECTOR
JUMPER
CONNECTOR
TRANSMISSION
MOUNTING BOLTS
TRANSMISSION
HANGER