Acura NSX 1991 Manual page 741

Main Menu
Under-dash Fuse Box
Removal/Installation
SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS section 24 before performing repairs or service.
Removal:
1. Disconnect both the negative cable and positive
cable from the battery.
2. Carefully remove the side sill pad (pull it up, rear
end first).
3. Remove the fuse box door.
SIDE SILL PAD
4. Remove the three screws, then remove the side sill
trim.
5. Remove the under-dash fuse box mounting bolts.
Table of Contents
FUSE BOX
DOOR
SIDE SILL TRIM
6. Disconnect the under-dash fuse box connectors.
NOTE: The SRS main harness connector is double
locked. To remove it, first lift the connector lid,
then press the connector tab down and pull the
connector out.
7. Take out the under-dash fuse box.
TAB
SRS MAIN HARNESS