Acura NSX 1991 Manual page 589

Main Menu
Rear Window
Installation
8. Press the upper and lower moldings into position
around the entire edge of the rear window.
NOTE: Check that the upper and lower moldings
are not wrinkled or lifted away at the corners.
UPPER MOLDING
UPPER MOLDING
9. Scrape or wipe the excess adhesive off with a put-
ty knife or towel.
NOTE: Use a soft shop towel dampened with
alcohol to remove adhesive from the rear window
or upper and lower moldings.
10. After the adhesive is dry, install the rear defogger
sub-harness and ground cable/antenna lead in the
upper molding.
Right Side:
Ground cable/
Antenna lead INNER GLASS
OUTER GLASS
UPPER MOLDING
Table of Contents
REAR WINDOW
LOWER
MOLDING
LOWER MOLDING
END CAP
UPPER
MOLDING
LOWER
OUTER GLASS MOLDING
INNER GLASS
UPPER MOLDING
Left Side:
Rear defogger
sub-harness
UPPER MOLDING
11. Set the rear window upright on the body, then
center it in the opening. Make alignment marks by
marking lines across the rear window and body with
a grease pencil at the four points shown.
ALIGNMENT MARKS
12. Glue the upper and lower rubber dams to the inside
face of the rear window, as shown, to contain the
adhesive during installation.
NOTE: Be careful not to touch the inner glass
where adhesive will be applied.
REAR WINDOW
REAR WINDOW
UPPER
RUBBER
DAM
INNER GLASS
LOWER RUBBER DAM
INNER
GLASS