Acura NSX 1991 Manual page 485

Main Menu
Rear Damper
Removal
1. Remove the rear wheels.
2. Remove the lower rear hatch glass trim.
REAR HATCH GLASS
TRIM
3. For NSX-T, remove the engine cover support rod
from the strut brace, then position the end of the rod
on the window lock mechanism to support the
engine cover.
NOTE: To prevent damage to the window lock
mechanism, place a shop towel over the mechanism.
STRUT BRACE
SHOP TOWEL
Table of Contents
ENGINE
COVER
SUPPORT ROD
WINDOW LOCK MECHANISM
4. Remove the three self-locking nuts.
5. Remove the rear strut brace.
STRUT BRACE
Corrosion resistant bolt/nut
6. Hold the damper lower mount of stabilizer link with
a wrench, then remove the damper mounting nut.
7. Hold the ball pin of the stabilizer link with a hex
wrench, then loosen the self-locking nut.
DAMPER MOUNTING NUT
12 x 1.25 mm
Replace.
95 N-m (9.5 kg-m, 69 Ib-ft)
STABILIZER LINK
Corrosion resistant bolt/nut
SELF-LOCKING NUT
10 x 1.25 mm
Replace.
WRENCH
HEX WRENCH
SELF-LOCKING NUT
12 x 1.25 mm
Replace.
85 N-m (8.5 kg-m, 61 Ib-ft)