Main Menu
5. Remove the mounting screws, then remove the side air vents from each side of the dashboard.
6. Remove the dashboard end plate, and fold the console carpet down (see page
7.
Remove the dashboard mounting bolts and screw, then lift and remove the dashboard.
NOTE:
Take care not to scratch the dashboard.
Use protective tape on the bottom of the front pillar trim.
To prevent damage to the shift lever and indicator panel (A/T), wrap them with a shop towel.
CAUTION: When prying with a flat tip screwdriver, wrap it with protective tape or a shop towel to prevent damage.
NOTE: If necessary, remove the defrost panel.
MOUNTING BOLTS
MOUNTING BOLTS
SIDE AIR VENT
DASHBOARD
MOUNTING SCREWS
8. Installation is the reverse of the removal procedure.
NOTE:
Make sure the dashboard fits onto the guide pin and defrost panel correctly.
Before tightening the mounting bolts, make sure the wire harnesses are not pinched.
Table of Contents
DEFROST
PANEL
PROTECTIVE
TAPE
DASHBOARD
MOUNTING BOLTS
DASHBOARD
END PLATE
DASHBOARD
MOUNTING BOLTS
20-47('94-'96)
DASHBOARD
GUIDE PIN
DASHBOARD
SRS UNIT
SHOP TOWEL
CONSOLE CARPET
: CORROSION RESISTANT BOLT
('91-'93)).
RETAINER (4)
DEFROST PANEL
SCREW
PASSENGER'S
AIRBAG
DASHBOARD
MOUNTING BOLTS