Acura NSX 1991 Manual page 600

Main Menu
Seat Belts
Replacement
SRS wire harnesses are routed near the retractor.
All SRS wire harnesses and connec-
tors are colored yellow. Do not use electrical test
equipment on these circuits.
CAUTION:
Be careful) not to damage the SRS wire
harnesses when servicing the retractor.
Remove the short connector (RED) from the its
holder and disconnect the SRS wire harness
connector, then connect the short connector
(RED) to the tensioner connector.
NOTE: To prevent dust, wrap the SRS wire
harness connector with a protective cover.
CAUTION: Check the seat belts for damage, and replace them if necessary. Be careful not to damage them during
removal and installation.
1. Remove:
Seat (see page 20-39('93-'96), 38)
Center pillar trim panel (see page 20-38)
2. Remove the three anchor bolts, retractor bolt and retractor mounting bolt, then remove the seat belt and seat belt
buckle.
CAUTION: When removing the retractor, do not touch the seat belt tensioner.
NOTE: When removing the anchor bolts and retractor bolt, use a 17 mm socket or box-end wrench.
RETRACTOR MOUNTING
BOLT
6 x 1.0 mm
13 N·m (1.3kg-m, 9 Ib-ft)
SEAT BELT
TENSIONER
RETRACTOR BOLT
7/16-20 UNF
33 N·m (3.3 kg-m, 24 Ib-ft)
SEAT BELT BUCKLE
* CENTER ANCHOR BOLT
7/16-20 UNF
33 N·m (3.3 kg-m, 24 Ib-ft)
Disconnect the connector (driver's only).
Table of Contents
RETRACTOR
PROTECTIVE
BAG
RETRACTOR
SEAT BELT
TENSIONER
PROTECTIVE
COVER
SRS WIRE
HARNESS
SRS WIRE HARNESS
CONNECTOR
* UPPER ANCHOR BOLT
7/16-20 UNF
33 N·m (3.3 kg-m.
24 Ib-ft)
CENTER PILLAR TRIM
PANEL
(see page 20-38)
SEAT BELT
* LOWER ANCHOR BOLT
TENSIONER
CONNECTOR
CONNECTOR
HOLDER
SHORT
CONNECTOR
(RED)
CENTER PILLAR
TRIM PANEL
CAP
7/16-20 UNF
33 N·m (3.3 kg-m, 24 Ib-ft)
(cont'd)