Acura NSX 1991 Manual page 393

Main Menu Main Menu
7. Install the spring and cap, then fit the outboard
joint onto the driveshaft.
OUTBOARD JOINT
SPRING
CAP
8. Fit the circlip into the outboard joint inner groove.
CIRCLIP
Table of Contents Table of Contents
Align the roller holders with the
inboard joint as shown
below.
Spline
direction
HOLDER
Inboard joint side
NOTE: Wrap the splines with vinyl tape to prevent
damage to the boot.
9. Install the inboard boot to the driveshaft, then
remove the vinyl tape.
VINYL TAPE
10. Install the set ring into the driveshaft groove.
11. Install the spider on the driveshaft by aligning the
marks on the spider and end of the driveshaft.
12. Install the set ring into the driveshaft groove.
SET RING
Mark
SET RING
Mark
INBOARD BOOT
SPIDER