Main Menu
9. Remove the mounting screws, then remove the
front sash panel from the front sash.
FRONT SASH
10. Remove the outer molding (see page
('93-'96),11('91-'92)
11. Remove the mounting bolts and locknut, then
remove the front sash.
NOTE:
Hold the adjusting bolt with a hex wrench when
removing the locknut.
Scribe a line around the locknut to show the
original adjustment.
FRONT SASH
MOUNTING BOLT
LOCKNUT
*6
x 1.0 mm
*8 x 1.25 mm
22 N·m(2.2kg-m,
8 N·m (0.8 kg-m,
16 Ib-ft)
5.8 Ib-ft)
: CORROSION RESISTANT BOLT/NUT
Table of Contents
FRONT SASH PANEL
MOUNTING
SCREW
20-12
LOCKNUT
ADJUSTING BOLT
MOUNTING BOLT
6 x 1.0 mm
8 N·m (0.8 kg-m,
5.8 lb-ft)
LOCKNUT
12. Remove the mounting bolt, locknut and adjusting
bolt. Remove the rear sash, then disconnect the
handle rod.
NOTE:
Before removing the adjusting bolt, measure and
record the clearance
and door.
Scribe a line around the locknut to show the
original adjustment.
Take care not to bend the handle rod.
HANDLE ROD
REAR SASH
LOCKNUT
*8
1.25 mm
x
22 N·m (2.2 kg-m,
16 Ib-ft)
*: CORROSION RESISTANT 80LT/NUT
13. To replace the outer handle, remove the mounting
screws from the rear sash.
NOTE: Apply grease to the moving surfaces.
OUTER HANDLE
between the rear sash
REAR
SASH
DOOR
LOCKNUT
ADJUSTING
BOLT
MOUNTING BOLT
*6
1.0 mm
x
8 N·m 40.8 kg-m,
5.8 Ib-ft)
MOUNTING
SCREW
CAP
REAR SASH
(cont'd)