Acura NSX 1991 Manual page 989

Main Menu
Engine Removal/Installation
(cont'd)
18. Remove the breather pipe, then remove the air in-
take duct and the air cleaner case.
6 x 1.0 mm
10 N . m (1.0kg-m, 7 Ib-ft)
19. Disconnect the evaporative emission (EVAP) con-
trol canister hose from throttle body.
20. Disconnect the brake booster vacuum hose from
the intake manifold.
EVAP CONTROL CANISTER
EVAP CONTROL
CANISTER
HOSE
Table of Contents
AIR CLEANER
CASE
BREATHER PIPE
BRAKE BOOSTER
VACUUM HOSE
21. Disconnect the two engine wire harness connec-
tors from the side wire harness at left side of
engine compartment, and remove the engine wire
harness terminal and the starter cable terminal
from the main fuse box and clamps.
22. Remove the ground cable from the transmission.
MAIN FUSE BOX
ENGINE WIRE
HARNESS
23. Remove the water hoses and the heater hose from
the water passage.
WATER HOSES
: CORROSION RESISTANT BOLT
6 x 1 . 0 mm
10 N . m (1.0 kg-m,
7 Ib-ft)
HEATER HOSE