Main Menu
Change Holder Assembly, Shift Fork
Clearance Inspection
1. Measure the clearance between the shift piece and
shift arm.
Standard:
0.05—0.25 mm
(0.002-0.010 in)
Service Limit: 0.5 mm (0.020 in)
SHIFT ARM
2. If the clearance exceeds the service limit, measure
the width of the shift arm.
Standard: 12.9-13.0 mm (0.508-0.512 in)
If the width of the shift arm is less than the stan-
dard, replace the shift arm with a new one.
If the width of the shift arm is within the standard,
replace the shift piece with a new one.
Table of Contents
SHIFT PIECE
SHIFT ARM
3.
Measure the clearance between the interlock and
select arm.
Standard: 0.03-0.15 mm (0.001 - 0.006 in)
4.
If the clearance exceeds the standard, measure the
width of the interlock finger.
Standard: 11.95 - 12.00 mm
(0.470-0.472 in)
If the width of the interlock is less than the stan-
dard, replace the interlock with a new one.
If the width of the interlock is within the standard,
replace the select arm with a new one.
INTERLOCK
SELECT ARM
INTERLOCK