Acura NSX 1991 Manual page 496

Main Menu
6. Clean the caliper thoroughly; remove any rust, and
check for grooves and cracks.
7. Install the pad retainers.
8. Apply Molykote® M77 to both sides of inner shim
A and the back of the pads. Wipe excess grease off
the shims.
9. Install the brake pads.
• When reusing the pads, always reinstall the
brake pads in their original positions to prevent
loss of braking efficiency.
• Contaminated brake discs or pads reduce stop-
ping ability. Keep grease off the brake discs or
pads.
NOTE:
• Install the inner pad with its wear indicator fac-
ing upward.
• Apply Molykote®
19-5). Wipe excess grease off the shims.
10. Install the brake pad shims correctly.
Table of Contents
M77 to the shims (see page
11. Push in the pistons so that the caliper will fit over
the brake pads.
12. Set the caliper down into position, then install the
brake hose mounting bolts and the caliper moun-
ting bolts. Tighten the bolts to the specified torque.
13. Depress the brake pedal several times to make sure
the brakes work, then test-drive the car.
NOTE: Engagement of the brake may require a
greater pedal stroke immediately after the brake
pads have been replaced as a set. Several applica-
tions of the brake pedal will restore the normal
pedal stroke.
14. Install the front wheels and torque the wheel nuts.
NOTE: Clean the mating surface of the wheel and
hub before installing the wheel.