Acura NSX 1991 Manual page 513

Main Menu
Rear Caliper
Reassembly (cont'd)
8. Install a new cup with its groove facing the bearing
A side on the adjusting bolt.
9. Fit the bearing A, spacer, adjusting spring B and
spring cover on the adjusting bolt, and install in the
caliper cylinder.
NOTE: Install the bearing A with its open end fac-
ing the spacer.
10. Adjust the special tool as shown.
07HEA-SG00100
Table of Contents
11. Install the special tool as shown.
12. Compress the spring until it bottoms out.
13. Check that the flared end of the spring cover is
14. Install the circlip, then remove the brake spring
15. Install the adjusting nut, adjusting spring A, and
below the circlip groove.
compressor.
NOTE: Check that the circlip is seated in the
groove properly.
SNAP RING PLIERS
07914-SA50000
washer, then secure with the circlip.
07HAE-SG00100