Acura NSX 1991 Manual page 477

Table of Contents

Advertisement

Main Menu
Rear Suspension
Hub Replacement
1.
Remove the center cap, then pry the spindle nut
lock tab away from the spindle and loosen the nut.
2.
Raise the car, and support it with safety stands (see
Section
1).
SPINDLE NUT
26 x 1.5 mm
Replace.
NOTE: After tightening, use a drift
to stake spindle nut shoulder
against the driveshaft.
3.
Remove the rear wheels.
NOTE: Before installing the wheel, clean the
mating surfaces of the brake disc and inside of the
wheel.
4.
Remove the spindle nut.
5.
Remove the wheel sensor from the knuckle and the
rear of the lower control arm, then secure the wheel
sensor wire to the suspension arm.
NOTE:
• Do not disconnect the wheel sensor.
• Be careful when installing the sensors to avoid
twisting wires.
22 N-m
(2.2 kg-m,
16 Ib-ft)
WHEEL SENSOR
Corrosion resistant bolt/nut
Table of Contents
WHEEL NUT
110 N-m
(11 kg-m, 80 Ib-ft)
10 N-m
(1.0 kg-m, 7 Ib-ft)
6.
Remove the banjo bolt and disconnect the brake
hose, then remove the brake hose clamp from the
knuckle.
CAUTION: Avoid spilling brake fluid on painted,
plastic or rubber surfaces as it can damage the
finish; wash spilled brake fluid off immediately with
clean water.
BANJO BOLT
35 N-m (3.5 kg-m, 25 Ib-ft)
WASHER
Replace.
Corrosion resistant bolt/nut
7.
Remove the rear caliper by removing the mounting
bolts.
CALIPER BRACKET MOUNTING BOLT
110 N-m (11 kg-m, 80 Ib-ft)
Corrosion resistant bolt/nut
BRAKE HOSE
BOLT 6 mm
10 N-m (1.0 kg-m, 7 Ib-ft)
CALIPER ASSEMBLY

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nsx 1992Nsx 1993Nsx 1994Nsx 1995Nsx 1996

Table of Contents