Acura NSX 1991 Manual page 74

Main Menu
25. Loosen the idler pulley center nut and adjusting nut,
then remove the air conditioning (A/C) compressor
belt.
ADJUSTING
NUT
A/C COMPRESSOR
BELT
26. Move the trunk carpet, and disconnect the right rear
wheel sensor connector. Push the wire and connec-
tor through the body hole into the engine compart-
ment.
Table of Contents
IDLER PULLEY
CENTER NUT
45 N-m (4.5 kg-m,
33 Ib-ft)
RIGHT REAR SENSOR
CONNECTOR
27. Raise the hoist to full height.
28. Remove the slave cylinder (M/T see
• Do not disconnect the clutch hose.
29. Remove the lower cover, then remove the shift
cable and select cable (M/T see
30. Remove the cable cover, then remove the shift
cable (A/T).
NOTE:
• Take care not to bend the cable when removing
it. Always replace a kinked cable with a new one.
• Adjust the cable when installing.
31. Remove the engine under guard and the center rod
assembly.
A/T:
SHIFT CABLE
CENTER ROD
ASSEMBLY
8 x 1.25 mm
22 N-m (2.2 kg-m,
16 Ib-ft)
UNDER GUARD
10 x 1.25 mm
60 N-m (6.0 kg-m, 43 Ib-ft)
section 12).
section 13).
CONTROL LEVER
CABLE COVER
6 x 1.0 mm
8 N-m (0.8 kg-m, 6 Ib-ft)
6 x 1.0 mm
12 N-m (1.2 kg-m, 9 Ib-ft)