Acura NSX 1991 Manual page 470

Main Menu
31. Remove the compliance pivot assembly by remov-
ing the bolts and nuts shown.
32. Remove the upper control arm assembly by remov-
ing the flange bolt shown.
COMPLIANCE
PIVOT ASSEMBLY
FLANGE BOLT
10 x 1.25 mm
60 N-m
(6.0 kg-m, 43 Ib-ft)
Corrosion resistant bolt/nut
Table of Contents
SELF-LOCKING
NUTS
12 x 1.25 mm
Replace.
95 N-m
(9.5 kg-m, 69 Ib-ft)
FLANGE BOLTS
10 x 1.25 mm
60 N-m
(6.0 kg-m, 43 Ib-ft)
NOTE:
• Install the upper control arm on the frame before
installing the compliance pivot assembly.
• Install the compliance pivot bolts and nuts. Tor-
que them to the specified torque in the order.
1. Loosely tighten the flange bolt
2. Insert the stud bolts
3. Install the three flange bolts
specified torque.
4. Install the two flange bolts
specified torque.
5. Tighten the flange bolt
6. Install the 12 mm self-locking nuts
to the specified torque.
STUD BOLT
FLANGE BOLTS
10 x 1.25 mm
60 N-m
(6.0 kg-m, 43 Ib-ft)
FLANGE BOLTS
12 x 1.25 mm
95 N-m
(9.5 kg-m, 69 Ib-ft)
into the frame.
and tighten to the
and tighten to the
and tighten
SELF-LOCKING
NUTS
12 x 1.25 mm
Replace.
95 N-m
(9.5 kg-m, 69 Ib-ft)
UPPER CONTROL
ARM
FLANGE BOLT
12 x 1.25 mm
95 N-m
(9.5 kg-m, 69 Ib-ft)
Corrosion resistant
bolt/nut