Acura NSX 1991 Manual page 745

Main Menu
Ignition Switch
Steering Lock Removal/Installation
6. Disconnect the ignition switch 7-P and 8-P connec-
tors.
7. Remove the column holder mounting bolts and the
mounting nuts, and lower the steering column
assembly.
CAUTION: Be careful not to damage the SRS wire
harness.
39 N-m
(3.9 kg-m, 28 Ib-ft)
8. Center-punch the shear bolt, and drill its head off
with a 5 mm (3/16 in) drill bit.
CAUTION: Do not damage the switch body.
9. Remove the shear bolt from the switch body.
Table of Contents
10. Insert the key, and turn it to "I".
11. Push the lock pin, and pull out the steering lock
16 N-m
(1.6 kg-m, 12 Ib-ft)
Installation:
1.
2.
3.
4.
assembly.
Turn the key to "I", push the pin, and insert the
steering lock assembly into the steering column
until it clicks into place.
Loosely tighten the new shear bolt. Make sure the
projection on the ignition switch is aligned with the
hole in the steering column.
Insert the ignition key, and check for proper opera-
tion of the steering wheel lock and that the ignition
key turns freely.
Tighten the shear bolt until the hex head twists off.
SHEAR BOLT
/
TWIST-OFF PORTION
STEERING LOCK
BODY