Table of Contents
Advertisement
Main Menu
Front Bumper
Replacement
1.
Loosen the mounting screw, then pull the right and left front turn signal lights out and disconnect the connectors.
2.
Remove the skirt covers, then remove the bumper mounting bolts on each side, and lower skirt mounting bolt.
3.
Lower the inner fender, then remove the bumper mounting nuts and the skirt mounting bolts from inside the front
fender on each side.
4.
Lift and remove the front bumper.
NOTE:
• Disconnect the washer hose, horn connecters, and ambient sensor connector.
• An assistant is helpful when removing the front bumper.
• Take care not to scratch the front bumper.
BUMPER BRACKET HOOK
BUMPER MOUNTING BOLTS
8 x 1.25 mm 22 N-m
(2.2 kg-m, 16 Ib-ft)
5.
Installation is the reverse of the removal procedure.
NOTE: Insert the bumper bracket hooks into the bumper bracket holes.
Table of Contents
BUMPER BRACKET HOLE
HORN
SKIRT COVER
SKIRT MOUNTING BOLTS
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
CONNECTORS
AMBIENT
SENSOR
FRONT TURN
SIGNAL LIGHT
SKIRT COVER
LOWER SKIRT MOUNTING
BOLT
BUMPER MOUNTING NUTS
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
INNER FENDER
FRONT BUMPER
MOUNTING SCREW
FRONT TURN
SIGNAL LIGHT
CONNECTORS
CORROSION RESISTANT BOLT/NUT
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
