Acura NSX 1991 Manual page 895

Main Menu
Trunk Opener
Opener Switch Test
1. Remove the driver's door panel, then push the switch
out of the door panel as shown.
2. Check for continuity between the terminals.
• There should be continuity between the A and B
terminals when the switch is pushed.
• There should be no continuity when the switch
is released.
Table of Contents
1.
2.
TRUNK LATCH
DOOR
PANEL
TRUNK OPENER
3.
4. Install in the reverse order of removal.
Solenoid Test/Replacement
Open the trunk lid, and remove the trunk side trim
panel.
Disconnect the 2-P connector from the solenoid
assembly, and test solenoid operation by connec-
ting battery power and ground to the A and B ter-
minals momentarily.
View from
terminal side
BRACKET
CABLE
To remove the solenoid, remove the two bolts, then
disconnect the trunk opener cable from the
solenoid assembly.
SOLENOID
ASSEMBLY
SOLENOID
ASSEMBLY
BRACKET
BOLT
OPENER CABLE