Acura NSX 1991 Manual page 80

Main Menu
5. Install the side engine mount, then tighten the bolts
in the numbered sequence as shown (
12 x 1.26 mm
73 N·m (7.3 kg-m,
53 Ib-ft)
Replace.
SIDE ENGINE
MOUNT
6. Tighten the transmission mount mounting bolt.
MOUNTING BOLT
12 x 1.25 mm
95 N·m (9.5 kg-m, 69 Ib-ft)
Table of Contents
- ),
x
12 1.25 mm
95 N·m (9.5 kg-m,
69 Ib-ft)
7. Tighten the rear mount mounting bolt.
Check that the spring clip on the end of each
driveshaft clicks into place.
CAUTION: Use new spring clips.
Bleed air from the cooling system (see page 10-5).
Bleed air from the brake lines {see
Check the clutch pedal free play (see
Adjust the clutch guide assemblies when disas-
sembling clutch (see
Check that the transmission shifts into gear
smoothly.
Adjust the alternator belt (see
Adjust the A/C compressor belt (see
Clean battery posts and cable terminals with
sandpaper, assemble, then apply grease to pre-
vent corrosion.
Inspect for fuel leakage (see
After assembling the fuel line parts, turn on
the ignition switch (do not operate the starter)
so that the fuel pump operates for approxi-
mately two seconds and the fuel line pressu-
rizes. Repeat this operation two or three times
and check for fuel leakage at any point in the
fuel line.
Check and adjust wheel alignment (see
Refill the engine with engine oil (see page
Models), ('93-Model),or
Refill the transmission with oil/fluid (see
13 or 14).
MOUNTING BOLT
12 x 1.25 mm
77 N·m (7.7 kg-m, 56 Ib-ft)
Replace.
section 19).
section 12).
section 12).
section 23).
section 22).
section 11).
section 18).
8-4 ('91-'92
('94-'96 Models).
section