Table of Contents
Advertisement
Main Menu
Preset Torque
Inspection
On-Car:
1.
Block the front wheels.
2.
Shift to low gear.
3.
Lift up rear wheels, and place the safety stand (Lift
and Support Points, see
4.
Measure preset torque clockwise using a torque
wrench as shown.
Standard:
120-280 N-m (12-28 kg-m,
87-203 Ib-ft)
Service Limit: 60 N-m (6 kg-m, 43 Ib-ft)
TORQUE WRENCH
RIGHT REAR WHEEL
5.
If preset torque is less than the service limit, replace
the limited slip differential clutch set.
NOTE: Adjust the 65 mm (differential housing cover
side) and 112 mm (differential housing cover side)
shims whenever the clutch set is replaced.
Table of Contents
section
1).
SAFETY STAND
Assembly:
Place one special tool in a vise. Place the left side
of the differential assembly on the special tool, then
preset the differential with 3 - 5 rotations, counter-
clockwise.
2.
Measure preset torque counterclockwise using a tor-
que wrench as shown.
Standard:
60-140 N-m (6-14 kg-m,
43-101 Ib-ft)
Service Limit: 30 N-m (3 kg-m, 22 Ib-ft)
TORQUE WRENCH
3.
If preset torque is less than the service limit, replace
the limited slip differential clutch set.
NOTE: Adjust the 65 mm and 112 mm shims
whenever the clutch set is replaced.
DIFFERENTIAL
INSPECTION TOOLS
07MAJ-PR90100
DIFFERENTIAL
INSPECTION TOOLS
07MAJ-PR90100
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
