Acura NSX 1991 Manual page 306

Main Menu
Transmission Assembly
Removal
20. Remove the intermediate shaft heat cover and the intermediate shaft mounting bolts.
21. Pry the intermediate shaft out of the differential. Pull and remove it.
NOTE:
• Coat all precision finished surfaces with clean engine oil or grease.
• Tie plastic bags over the driveshaft ends.
Corrosion resistant bolt/nut
INTERMEDIATE SHAFT
SUPPORT BASE
INTERMEDIATE SHAFT
22. Remove the parking brake cable holder and the wheel sensor wire clamp.
23. Remove the bolt, and separate the toe control arm from the side beam (see
24. Remove the damper fork bolt (see
25. Remove the bolts, and separate the lower control arm from the side beam.
26. Pry the driveshaft out of the differential. Pull and remove it.
NOTE:
• Coat all precision finished surfaces with clean engine oil or grease.
• Tie plastic bags over the driveshaft ends.
Corrosion resistant bolt/nut
LOWER CONTROL ARM
Table of Contents
section 18).
DAMPER FORK BOLT
WHEEL SENSOR
WIRE CLAMP
ADJUSTING
SELF-LOCKING NUT
BOLT
Replace.
section
SELF-LOCKING NUT
Replace.
TOE CONTROL ARM
ADJUSTING
SELF-LOCKING NUT
CAM
Replace.
INTERMEDIATE SHAFT
HEAT COVER
INTERMEDIATE SHAFT
MOUNTING BOLT
18).
PARKING BRAKE
CABLE HOLDER
FLANGE BOLT
SET RING
Replace.