Acura NSX 1991 Manual page 394

Main Menu
Driveshafts
Reassembly
13. Fit the rollers to the spider with their high shoulders
facing outward.
CAUTION:
• Reinstall the rollers in their original positions on
the spider.
• Hold the driveshaft assembly with the rollers up
to prevent them from falling off.
14. Pack the joint with joint grease included in the new
joint boot set.
Grease Quantity: 120-130 g (4.2-4.6 oz)
Table of Contents
SPIDER
ROLLER
High shoulder faces
toward outside.
1 5. Fit the inboard joint onto the driveshaft.
INBOARD JOINT
16. Adjust the length of the driveshafts to the figure
below, then adjust the boots to halfway between
full compression and extension.
NOTE: The ends of the boots seat in the grooves
of the driveshaft and joint.
Left Driveshaft
M/T: 501.0-506.0 mm (19.72-19.92 in)
A/T: 507.0-512.0 mm (19.96-20.16 in)
Right Driveshaft
M/T and A/T: 542.0-547.0 mm (21.34-21.54 in)
Align the roller holders with the
inboard joint as shown
below.
Spline
direction
HOLDER