Acura NSX 1991 Manual page 570

Main Menu
Doors
Moldings Removal
NOTE: Lower the glass fully.
Remove: (see pages 20-7('93-'96),6('91-'92),
8('93-'96),7('91-'92)
Trim plate
Inside door handle
Inner molding:
NOTE: Pry the clips out using a flat tip
screwdriver, then pull up the inner molding.
INNER MOLDING
INNER MOLDING
Outer molding:
NOTE:
Remove the front sash panel (see page
('93-'96),8('91-'92)
Starting at the front, release the clips, and lift
and slide the outer molding forward.
CLIP (6)
FRONT SASH
PANEL
MOUNTING
SCREW
OUTER
MOLDING
REAR SASH
STABILIZERS
Installation is the reverse of the removal procedure.
NOTE:
Before installing, set the clips onto the moldings.
If necessary, replace any damaged clips.
: CORROSION RESISTANT SCREW
Table of Contents
Sash covers
Door panel
CLIP
20-9
and mounting screw.
SHOP TOWEL
CLIP OUTER
MOLDING
OUTER
MOLDING
Door Removal
1. Lower the glass fully.
2. Remove the seat (see page
3. Disconnect the connectors.
4. Remove the door by removing the door mounting
bolts and detent rod pin, and by pulling out the wire
harness.
CAUTION: Place a shop towel or rubber pad on the
jack to prevent damage to the door.
NOTE: Let an assistant hold the door.
Lower the glass.
DOOR
SHOP TOWEL/
JACK
RUBBER PAD
DETENT ROD
PIN
5. Installation is the reverse of the removal procedure.
NOTE: Adjust the door position (see page 20-19).
('93-'96),18('91-'92)
: CORROSION RESISTANT BOLT
20-39('93-'96),38('91-'92)
DOOR MOUNTING
BOLTS
8 x 1.25 mm
30 N·m (3.0 kg-m,
22 Ib-ft)
CONNECTORS
WIRE HARNESS