Acura NSX 1991 Manual page 891

Main Menu
Horns
Switch Test (cont'd)
5. Disconnect the cable reel harness 6-P connector
from the SRS main harness, then connect test
harness C only to the cable reel harness.
CABLE REEL
HARNESS
6-P CONNECTOR
TEST
HARNESS C
07LAZ - SL40300
6. Check for continuity between the No. 3 terminal
and body ground with the horn switch pressed.
There should be continuity.
• If there is continuity, the horn switch is OK.
• If there is no continuity, go to step 7.
Table of Contents
7.
ACCESS
PANEL
Continuity?
Remove the Torx bolts using a Torx T30 bit, then
remove the airbag assembly.
Store a removed airbag assembly
with the pad surface up. If the airbag is improperly
stored face down, accidental deployment could
propel the unit with enough force to cause serious
injury.
TORX BOLT
10 N-m (1.0 kg-m, 7.2 Ib-ft)
Replace.
Use a Torx T30 bit
CRUISE CONTROL
SWITCH COVER