Main Menu
7. Disconnect the 6-P connector.
MOUNTING BOLT/NUT
10 N-m (1.0kg-m. 7.2 Ib-ft)
BRACKET
MOTOR ARM JOINT
8. Remove the two mounting bolts and the mounting
nut.
9. Pry the retractor linkage off the motor arm.
10. Pull out the retractor motor.
11. Install in the reverse order of removal, and:
• Make sure there is no interference between the
wire harness and linkage.
• Coat the joint with grease and make sure the link-
age moves smoothly.
Table of Contents
RETRACTOR
MOTOR
6-P CONNECTOR