Acura NSX 1991 Manual page 428

Main Menu
Steering Wheel
Disassembly/Reassembly
Store a removed airbag assembly with the
pad surface up. If the airbag is improperly stored face
down, accidental deployment could propel the unit with
enough force to cause serious injury.
NOTE: If an intact airbag assembly has been removed
from a scrapped car or has been found defective or dam-
aged during transit, storage or service, it should be
deployed (see section 24).
STEERING WHEEL
LOWER COVER
ACCESS PANEL
Table of Contents
STEERING WHEEL
STEERING
WHEEL NUT
Replace.
CRUISE CONTROL SET/
RESUME SWITCH
CAUTION:
• Carefully inspect the airbag assembly before install-
ing. Do not install an airbag assembly that shows
signs of being dropped or improperly handled, such
as dents, cracks or deformation.
• Always keep the short connector on the airbag con-
nector when the harness is disconnected.
• Do not disassemble or tamper with the airbag assem-
bly.
TORX BOLT
10 N.m
(1.0 kg-m, 7 Ib-ft)
Replace.
AIRBAG ASSEMBLY