Acura NSX 1991 Manual page 373

Main Menu
Preset Torque
Inspection
On-Car:
1. Lift up right rear wheel, and place the safety stand.
(Lift and Support Points, see
2. Block the other three wheels.
3. Measure preset torque clockwise using a torque
wrench as shown.
Standard: 60–140 N·m
(6–14 kg-m, 43–101 Ib-ft)
Service Limits: 30 N·m (3 kg-m, 22 Ib-ft)
TORQUE WRENCH
RIGHT REAR WHEEL
4. If preset torque is less than the service limit,
replace the clutch discs with new ones.
NOTE: Adjust the thrust shim whenever the clutch
discs are replaced (see page 15-22).
Table of Contents
section 1).
SAFETY STAND
Assembly:
1. Place one special tool in a vise. Place the left side of
the differential assembly on the special tool, then
preset the differential with 3 – 5 rotations, both
clockwise and counterclockwise.
2. Measure preset torque clockwise using a torque
wrench as shown.
Standard: 60–140 N·m
(6–14 kg-m, 43–101 Ib-ft)
Service Limit: 30 N·m (3 kg-m, 22 Ib-ft)
TORQUE WRENCH
3. If preset torque is less than the service limit,
replace the clutch discs with new ones.
NOTE: Adjust the thrust shim whenever the clutch
discs are replaced (see page 15-22).
DIFFERENTIAL
INSPECTION TOOLS
07MAJ– PR90100
DIFFERENTIAL
INSPECTION TOOLS
07MAJ – PR90100