Acura NSX 1991 Manual page 855

Main Menu
Ceiling/Courtesy/Trunk Lights
Courtesy Light Test/Replacement
NOTE: The bulb or lens alone can be replaced without
having to remove the door panel.
1. Remove the door panel (see
2. Remove the two screws and the retainer plate, then
remove the light from behind the door panel.
3. Make sure that the bulb is OK, then check for con-
tinuity between the A and B terminals. There should
be continuity.
NOTE: This light has a built-in diode. To get an ac-
curate reading, either test it with a volt-ohmmeter
that compensates for diodes, or make sure you con-
nect your test leads to match the polarity shown.
BULB (3.4 W)
LENS
HOUSING
From No.34 (15A) FUSE
To DOOR SWITCH
Table of Contents
section 20).
DOOR PANEL
RETAINER
PLATE
Door Switch Test
1. Remove the door panel (see
2. Disconnect the 2-P connector from the door switch.
DOOR SWITCH (Built into door lock actuator assembly)
3. Check for continuity at the connector terminals.
• There should be continuity with the switch
released (door open).
• There should be no continuity with the switch
pushed (door closed).
section 20).
View from
terminal side
2-P CONNECTOR