Acura NSX 1991 Manual page 443

Main Menu
Retighten the locknut while holding the rack
guide screw with a wrench.
LOCKNUT WRENCH, 40 mm
07916 - SA50001
Table of Contents
LOCKNUT
25 N-m (2.5 kg-m, 18 Ib-ft)
Tie-rod installation:
5. Screw each rack end into the rack while holding the
lock washer so its tabs are in the slots in the rack
end.
NOTE: Install the stopper washer with the cham-
fered side facing out.
LOCK WASHER
Replace.
TAB
RACK END
6. Tighten the rack end securely, then bend the lock
washer back against the flat on the flange as shown.
NOTE: Coat the stopper washer with grease suffi-
ciently.
RACK END
55 N-m
(5.5 kg-m, 40 Ib-ft)
SLOT
STOPPER WASHER