Main Menu
Engine Removal/Installation
(cont'd)
10. Disconnect the resistor connector and fan motor
connector, then remove the engine room fan
assembly.
6 x 1.0 mm
.
10 N
m d.Okg.m, 7 Ib-ft)
ENGINE ROOM
FAN
6 x 1 . 0 mm
.
10 N
m (1.0 kg-m, 7 Ib-ft)
CORROSION RESISTANT BOLT
Table of Contents
ENGINE ROOM
FAN CONNECTOR
11. Remove the
rear trim
passenger's seat, then disconnect four connectors
from Engine Control Module (ECM) and five con-
nectors from floor wire harness.
ENGINE WIRE
HARNESS CONNECTORS
GROMMET
ENGINE WIRE
HARNESS
panels
behind the
ECM
PASSENGER'S
SEAT
FLOOR WIRE HARNESS
FUEL PUMP RESISTOR
CONNECTOR
GROUND
CABLE