Acura NSX 1991 Manual page 505

Main Menu
Rear Brake Pads
Inspection/Replacement
• Never use an air hose or dry brush to clean brake
assemblies,
Use an OSHA-approved vacuum cleaner to avoid
breathing brake dust.
1. Loosen the rear wheel nuts slightly, then raise each
side of the car and support it on safety stands (see
page 1-9 through 1-11).
Remove the rear wheels.
2. Remove the caliper shield.
3. Remove the lock pin and clevis pin. Remove the ca-
ble clip, and disconnect the cable from the arm.
Table of Contents
4. Remove the two caliper mounting bolts and the
caliper from the bracket.
CAUTION:
• Thoroughly clean the outside of the caliper to
prevent dust and dirt from entering inside.
• Support the caliper with a piece of wire so that it
does not hang from the brake hose.
If lining thickness is less than service limit at step
6, replace the brake pads as a set.