Acura NSX 1991 Manual page 353

Main Menu
12. Install a new set ring on the end of the left driveshaft and intermediate shaft.
13. Install the left driveshaft (see
14. Install the lower control arm to the side beam (see
CAUTION: Align the reference marks on the adjusting bolt, adjusting cam and lower control arm.
15. Install the damper fork bolt (see
16. Install the toe control arm to the side beam (see
CAUTION: Make sure that the arrow marks on the toe control arm are aligned.
17. Install the wheel sensor wire clamp and parking brake cable holder.
Corrosion resistant bolt/nut
SELF-LOCKING NUT
Replace
12 x 1.25 mm
95 N-m (9.5 kg-m, 69 Ib-ft)
6 x 1.0 mm
10 N-m
(1.0 kg-m, 7 Ib-ft)
WHEEL SENSOR WIRE CLAMP
LOWER CONTROL ARM
SELF-LOCKING NUT
Replace.
14 x 1.5 mm
125 N-m
(12.5 kg-m, 90 Ib-ft)
18. Install the intermediate shaft, and tighten the intermediate shaft mounting bolts to the intermediate shaft support
base.
19. Install the intermediate shaft heat cover.
Corrosion resistant bolt/nut
Table of Contents
section 16).
section
section 18).
section
SELF-LOCKING NUT
Replace.
DAMPER
12 x 1.25 mm
FORK BOLT
85 N-m (8.5 kg-m, 61 Ib-ft)
ADJUSTING
BOLT
SUPPORT BASE
INTERMEDIATE SHAFT
18).
18).
SET RING
Replace.
ADJUSTING
SELF-LOCKING NUT
CAM
Replace.
14 x 1.5 mm
125 N-m (12.5 kg-m, 90 Ib-ft)
8 x 1.25 mm
22 N-m (2.2 kg-m, 16 Ib-ft)
PARKING BRAKE CABLE HOLDER
FLANGE BOLT
12 x 1.25 mm
95 N-m
(9.5 kg-m, 69 Ib-ft)
TOE CONTROL ARM
6 x 1.0 mm
10 N-m (1.0 kg-m, 7 Ib-ft)
HEAT COVER
8 x 1.25 mm
22 N-m
(2.2 kg-m, 16 Ib-ft)