Acura NSX 1991 Manual page 389

Main Menu
12. Remove the self-locking nut and flange bolt.
13. Remove the self-locking nut and adjusting bolt,
then disconnect the lower control arm from the
sub-frame.
Corrosion resistant bolt/nut
LOWER CONTROL ARM
SELF-LOCKING NUT
14 x 1.5 mm
Replace.
125 N-m (12.5 kg-m, 90 Ib-ft)
14. Pull the knuckle outward, and remove the driveshaft
outboard joint from the knuckle using a plastic
hammer.
KNUCKLE
OUTBOARD JOINT
Table of Contents
14 x 1.5 mm
Replace.
125 N-m (12.5 kg-m, 90 Ib-ft)
ADJUSTING CAM
ADJUSTING BOLT
FLANGE BOLT
15. Pry the driveshaft assembly with a screwdriver as
shown to force the set ring past the groove.
SCREWDRIVER
3.5 mm
7 mm
16. Pry the inboard joint outward, then remove the
driveshaft and CV joint from of the differential case
or intermediate shaft as an assembly.
CAUTION:
• Do not pull on the driveshaft, as the CV joint
may come apart.
• Use care when prying out the assembly, and pull
it straight to avoid damaging the differential oil
seal or intermediate shaft dust seal.
INBOARD JOINT
17. Installation is the reverse order of removal.
After installing the driveshafts, adjust the wheel
alignment (see section 18).