Acura NSX 1991 Manual page 990

Main Menu Table of Contents
24. Disconnect the three connectors from the emission
control box.
Do not disconnect the vacuum hoses.
6 x 1.0 mm
10 N . m (1.0 kg-m,
7 Ib-ft)
CONNECTORS
25. Move the trunk carpet and disconnect the right rear
sensor connector. Push the wire and connector
through the body hole into the engine compart-
ment.
26. Remove the front engine mounting bolt (page
5-29).
EMISSION CONTROL
BOX
RIGHT REAR SENSOR
CONNECTOR
27. Raise hoist to full height.
28. Remove the clutch
transmission case (M/T see
Do not disconnect the clutch hose.
29. Remove the lower cover, then remove the shift
cable and select cable with cable bracket (M/T see
section 13).
30. Remove the cover, then remove the shift cable
(A/T see section 14).
NOTE:
Take care not to bend the cable when removing
it. Always replace a kinked cable with a new
one.
Adjust the cables when installing.
31. Remove the engine under guard and the center rod
assembly.
A/T:
SHIFT CABLE
CENTER ROD
ASSEMBLY
8 x 1 . 2 5 mm
22 N.m (2.2 kg-m,
16 Ib-ft)
UNDER GUARD
10 x 1.25 mm
60 N . m (6.0 kg-m, 43 Ib-ft)
: CORROSION RESISTANT BOLT/NUT
slave cylinder from the
section 12).
CONTROL LEVER
CABLE COVER
6 x 1 . 0 mm
8 N.m (0.8 kg-m, 6 Ib-ft)
6 x 1 . 0 mm
12 N . m (1.2 kg-m. 9 Ib-ft)
(cont'd)