Table of Contents
Advertisement
Main Menu
Illustrated Index
Clean all parts thoroughly in solvent and dry with compressed air.
Lubricate all parts with oil before reassembly.
NOTE:
• This transmission uses no gaskets between the major housings; use liquid gasket (P/N 08718-0001).
If 20 minutes have passed after applying liquid gasket, reapply it and assemble the housings and allow it to cure
at least 30 minutes after assembly before filling the transmission with oil.
• Always clean the magnet
CLUTCH RELEASE HANGER
RELEASE HANGER SPRING
RELEASE BEARING GUIDE
40 x 68 x 12.5 mm OIL SEAL
Replace.
14 x 20 mm DOWEL PIN
CLUTCH HOUSING
VEHICLE SPEED SENSOR (VSS)
DIFFERENTIAL SPEED SENSOR
O-RING
Replace.
RELEASE BEARING GUIDE COVER
REVERSE SHIFT FORK ASSEMBLY
13-16
13-15
Table of Contents
whenever the transmission housing is disassembled.
OIL GUIDE RING
90 mm WASHER
BEARING OUTER RACE
DIFFERENTIAL ASSEMBLY
• See
section 15
OIL GUIDE PLATE
44 x 72 x 23 mm NEEDLE BEARING
•Inspect for wear and operation.
BEARING RETAINING PLATE
COUNTERSHAFT ASSEMBLY
13-29
MAINSHAFT ASSEMBLY
• Index, page
13-23
75 mm SPRING WASHER
32 x 46 x 7 mm OIL SEAL
Replace.
TRANSMISSION MAGNET
SHIFT FORK ASSEMBLY
• Disassembly/Reassembly, page
13-22
OIL PUMP ASSEMBLY
• Disassembly/Reassembly, page
13-37
CHANGE HOLDER ASSEMBLY
• Disassembly/Reassembly, page
13-19
UPPER COVER
SELECT LEVER ASSEMBLY
13-17
13-43
REVERSE SHIFT ARM
14 x 20 mm DOWEL PIN
10 x 20 mm DOWEL PIN
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
