Acura NSX 1991 Manual page 574

Main Menu
Doors
Glass Adjustment (cont'd)
8. Adjust the Clearance "H" as follows:
a. Loosen the bolts and nuts securing the front sash,
rear sash and stopper plates, then move the front
sash all the way forward and move the rear sash
all the way backward.
NOTE: Hold the adjusting bolts with a hex
wrench when loosening the locknuts.
Loosen.
REAR SASH
STOPPER PLATES
b. Loosen the bolts securing the regulator assem-
bly, and move the regulator assembly fore or aft
to align the glass with the body at the front and
center pillars.
Table of Contents
"H" (See page 20-15
('93-'96),14('91-'92)
GLASS
FRONT
SASH
Loosen.
LOCKNUT
ADJUSTING
BOLT
GLASS
Loosen.
Loosen.
REGULATOR ASSEMBLY
c. Loosen the nuts securing the rear glass guide, and
adjust the glass fore and aft by moving the rear
glass guide.
NOTE: Hold the adjusting bolts with a hex
wrench when loosening the locknuts.
Loosen.
Loosen,
REAR GLASS GUIDE
d. Repeat steps b and c until clearance "H" is
within the specified limits, then secure the regu-
lator and glass guide. Press the stopper plates
against the glass stoppers, then secure the stop-
per plates.
NOTE: Check that the stopper plates contact the
glass stoppers evenly.
GLASS STOPPER
GLASS
LOCKNUT
ADJUSTING
BOLT
STOPPER PLATE
MOUNTING
NUT