Acura NSX 1991 Manual page 579

Front and Center Pillar Retainer/Upper Weatherstrip/
Main Menu
Center Pillar Panel
Replacement
Disassemble in numbered sequence.
CAUTION: Wear gloves to remove and install the retainer.
NOTE:
Check the upper weatherstrip for damage and deterioration, and replace it if necessary.
Take care not to bend the front and center pillar retainer.
After installing the upper weatherstrip, check for water leaks.
If necessary: Adjust the position of the door glass (see page 20-14('93-'96),13('91-'92).
If necessary: Replace any damaged clips.
FRONT PILLAR
RETAINER
SCREW (19)
Seal with black
weatherstrip adhesive.
Table of Contents
MOUNTING
NUTS
5 x 0.8 mm
4 N·m
(0.4 kg-m,
2.9 lb-ft)
Center pillar panel removal:
1. Open the door, and remove the center pillar trim
panel (see page 20-38('93-'96),37('91-'92).
2. Remove the mounting nuts from the hole in the
body panel, and pull the center pillar panel out by
hand.
NOTE: Do not drop the mounting nuts inside the
body panel.
FRONT PILLAR
RETAINER
GLASS
STOPPER
UPPER
WEATHERSTRIP
FRONT PILLAR
A-A Section
RETAINER
WINDSHIELD
SHOP TOWEL
CENTER PILLAR
RETAINER
SCREW (3)
UPPER
WEATHERSTRIP
C-C Section
FRONT PILLAR
RETAINER
UPPER
UPPER
WEATHERSTRIP
WEATHERSTRIP
SPECIAL BOLT (2)
ADHESIVE TAPE
CENTER PILLAR
PANEL
CENTER PILLAR
PANEL
Seal with black
weatherstrip adhesive.
CENTER PILLAR
PANEL
CENTER PILLAR
RETAINER
B-B Section
INSIDE
CUP
(4)