Acura NSX 1991 Manual page 603

Main Menu
Seat Belts
Child Seat Anchor Plate
An attachment point is provided for a child restraint
system which uses a top tether. The tether bracket and
bolt are available at your Acura dealer. The tether at-
tachment point is located on the panel behind the
passenger's seat-back.
1. Adjust the passenger seat fully forward to make
room behind the seat-back.
2. Using the dimensions shown, measure and mark
the location of the attachment point on the interior
panel.
3. Use a razor blade or sharp knife to carefully cut a 1
inch diameter circle at the point you marked. Cut
through one layer at a time. You will need to
remove two layers to reach the tether attachment.
4. Install the tether bracket and bolt and tighten to:
16 Ib-ft (22 N-m)
Make sure to route the tether through the space be-
tween the headrest and seat.
8 x 1.25 mm
22 N-m (2.2 kg-m, 16 Ib-ft)
CHILD SEAT
ANCHOR PLATE
100 mm
(25.4 in)
246 mm
(62.5 in)
NOTE:
• Do not remove the toothed washer from the
child seat anchor plate. Use the child seat an-
chor plate with the toothed washer attached to
it.
• When installing a child seat, follow the instruc-
tions of the manufacturer of the child seat.
• Additional anchor plates are available.
Do not use the anchor plate for any
other purpose; it is designed exclusively for in-
stallation of a child seat.
Table of Contents
Rearview Mirror
25 mm
(1 in)
Replacement
1. Carefully remove
screwdriver.
2. Loosen the lock bolt, then slide the mirror stay from
the lug.
MIRROR
COVER
3. Remove the lock bolt, then remove the toothed
lock washer and hold spring from the mirror stay.
4. Installation is the reverse of the removal procedure.
the cover with a flat tip
LUG
MIRROR STAY
LOCK BOLT
Counter-
clockwise
LOCK BOLT
Left-hand threads
TOOTHED LOCK WASHER
HOLD SPRING
MIRROR STAY